Description
If you’re dropping EMG HZ pickups into a guitar and dreading the soldering marathon, this kit skips it entirely. Built specifically for passive (non-active) HZ humbuckers, it bundles every solderless component required to wire a 1- or 2-pickup humbucker setup, so you can go from parts on the bench to a finished, playable guitar in an afternoon.
Note that this is strictly for guitar humbuckers — it’s not compatible with active EMG pickups or single-coil configurations. Everything snaps together with EMG’s connector system, keeping your wiring cavity clean and your tone consistent, since there’s no cold solder joints to second-guess down the road.
What’s in the box:
- 2x 500k Volume Pots
- 2x 500k Tone Pots
- 1x 12b Output Jack with Battery Clip
- 1x Output Cable
- 4x Interconnect Cables
- 2x Pickup Cables
Whether you’re upgrading a single-humbucker build or wiring up a full two-pickup setup, this kit gives you the parts count to match — no hunting for extra pots or cables, no guessing on values. Just a straightforward path to a properly wired passive HZ system.
Reviews
There are no reviews yet.