Description
Swapping in a set of EMG active humbuckers shouldn’t mean firing up a soldering iron and hoping your joints hold. This EMG wiring kit hands you every solderless piece needed to wire a 1 or 2 humbucker active guitar setup, snap-together simple and built to EMG’s own spec so impedance and signal stay clean from pickup to jack.
Long-shaft pots make this kit the right call for guitars with thicker tops or where your control cavity sits a bit deeper than standard. Because it’s solderless, you can dial in your configuration, test it, and adjust without melting anything or second-guessing a cold joint.
Important: this kit is designed specifically for guitar humbuckers and active pickup systems only — not passive setups, not basses.
What’s in the box:
- 2 Volume Pots
- 2 Tone Pots
- 1 12b Output Jack with Battery Clip
- 1 Output Cable
- 4 Interconnect Cables
- 3 Pickup Cables
Whether you’re finally installing that pair of EMGs that’s been sitting in a drawer or rewiring a guitar that’s due for an active upgrade, this kit takes the guesswork and the flux fumes out of the job. Everything clips together, so you’re back to playing faster than you’d expect.
Reviews
There are no reviews yet.